8-K/A 2013 annual vote results


UNITED STATES
SECURITIES AND EXCHANGE COMMISSION
WASHINGTON, D.C. 20549
FORM 8-K/A
(Amendment No. 1)
CURRENT REPORT
Pursuant to Section 13 or 15(d) of the Securities Exchange Act of 1934
 
 
 
Date of Report (Date of Earliest Event Reported):
 
May 15, 2013

CORE MOLDING TECHNOLOGIES, INC.
__________________________________________
(Exact name of registrant as specified in its charter)
 
 
 
Delaware
001-12505
31-1481870
_____________________
(State or other jurisdiction
_____________
(Commission
______________
(I.R.S. Employer
of incorporation)
File Number)
Identification No.)
 
 
 
800 Manor Park Drive, Columbus, Ohio
 
43228-0183
________________________________
(Address of principal executive offices)
 
___________
(Zip Code)

 
 
 
Registrant’s telephone number, including area code:
 
614-870-5000

Not Applicable
______________________________________________
Former name or former address, if changed since last report

Check the appropriate box below if the Form 8-K filing is intended to simultaneously satisfy the filing obligation of the registrant under any of the following provisions:

[ ] Written communications pursuant to Rule 425 under the Securities Act (17 CFR 230.425)
[ ] Soliciting material pursuant to Rule 14a-12 under the Exchange Act (17 CFR 240.14a-12)
[ ] Pre-commencement communications pursuant to Rule 14d-2(b) under the Exchange Act (17 CFR 240.14d-2(b))
[ ] Pre-commencement communications pursuant to Rule 13e-4(c) under the Exchange Act (17 CFR 240.13e-4(c))






Explanatory Note

This Current Report on Form 8-K/A (the “Amendment”) amends the Current Report on Form 8-K filed by Core Molding Technologies, Inc. (the “Company”) with the Securities and Exchange Commission on May 17, 2013 (the “Original Form 8-K”). The Original Form 8-K reported the final voting results of the Company’s 2013 Annual Meeting of Stockholders held on May 15, 2013 (the “Annual Meeting”). The sole purpose of this Amendment is to disclose the Company’s decision regarding how frequently it will conduct future stockholder advisory votes on compensation of the Company’s named executive officers (“Say on Pay”). No other changes have been made to the Original Form 8-K.



Item 5.07 Submission of Matters to a Vote of Security Holders.

As previously reported in the Original Form 8-K, in a non-binding advisory vote held at the Annual Meeting, the Company’s stockholders approved the Board of Directors' recommendation that a Say on Pay vote should occur on an annual basis.

The Company’s Board of Directors has considered the outcome of this advisory vote and determined that the Company will hold future Say on Pay votes on an annual basis until the occurrence of the next advisory vote on the frequency of Say on Pay votes. The next advisory vote regarding the frequency of Say on Pay votes is required to occur no later than the Company’s 2019 Annual Meeting of Stockholders.











SIGNATURES

Pursuant to the requirements of the Securities Exchange Act of 1934, the registrant has duly caused this report to be signed on its behalf by the undersigned hereunto duly authorized.

 
 
 
 
 
 
 
CORE MOLDING TECHNOLOGIES, INC.
October 11, 2013
 
By:
 
/s/ Kevin L. Barnett
 
 
 
 
 
 
 
 
 
Name: Kevin L. Barnett
 
 
 
 
Title: President and Chief Executive Officer